Guild of Project Controls: Compendium | Roles | Assessment | Certifications | Membership

Tips on using this forum..

(1) Explain your problem, don't simply post "This isn't working". What were you doing when you faced the problem? What have you tried to resolve - did you look for a solution using "Search" ? Has it happened just once or several times?

(2) It's also good to get feedback when a solution is found, return to the original post to explain how it was resolved so that more people can also use the results.

Short lead items Material list out for Turnaround

No replies

Dear planners,

Thanks for the support for posting posts which helps other planners anywhere in the world.


As a New to planning department, Our task phase is  Short lead items List out necessary for our Major turnaround, as per the instruction, we have to Look in GA, P&ID,Blinding list from operations,Isometric & Sap (for previous or installed material details). And then we have to compare and take the higher side or the most accurate of all this sheets.Well this seems very lengthy and awkard so i wanted suggestion or better ways to sort out the short lead item details which would be accurate and less time consuming

as of now we have to dump material details from sap then Check the P&ID then check the GA and accordingly check isometric if available and as per the line specification list out details for Gaskets,Stud-bolts & internals


Please share your ideas & experience !

Replies are much appreciated


Thanks & regards