Guild of Project Controls: Compendium | Roles | Assessment | Certifications | Membership

Tips on using this forum..

(1) Explain your problem, don't simply post "This isn't working". What were you doing when you faced the problem? What have you tried to resolve - did you look for a solution using "Search" ? Has it happened just once or several times?

(2) It's also good to get feedback when a solution is found, return to the original post to explain how it was resolved so that more people can also use the results.

Filter

4 replies [Last post]
moutaz aldeib
User offline. Last seen 2 years 23 weeks ago. Offline
Joined: 31 Dec 2003
Posts: 291
Groups: None
Dear Planners,

How to use the level 2 filter in P6? I need to apply filter by using both "And" & "Or"

Regards,

Moutaz

Replies

Zq qz
User offline. Last seen 12 years 11 weeks ago. Offline
Joined: 6 Jun 2003
Posts: 163
Groups: None
You can also do this in P6. Just familiarized your self with the codes. P6 is more powerful....make trials..
moutaz aldeib
User offline. Last seen 2 years 23 weeks ago. Offline
Joined: 31 Dec 2003
Posts: 291
Groups: None
Thanks everybody for responce, but it seems that filter in P3 is more powerful and easier than in P6.
In P6 as you stated you have to add many filters and consider them as levels.

Regards,

Moutaz
Zq qz
User offline. Last seen 12 years 11 weeks ago. Offline
Joined: 6 Jun 2003
Posts: 163
Groups: None
thats right...... keep it up
muhammad anwar
User offline. Last seen 3 years 37 weeks ago. Offline
Joined: 5 Feb 2007
Posts: 46
Groups: TILOS
Moutaz

You need to select ’All selected filters’ option on Filter pop up menu top[right hand side].
Then add filter in user defined filters (or Global/project filters)

1 - Filter 1 and define parameters

2 - Filter 2 and define parameters

Then select both filters in the check box.

at the bottom selece replace or highlight the activities.

Hope this will help

regards

Muhammad